| Removal and Installation Removal NOTE:Removal steps in this procedure may contain installation details. | | -
Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures). | | | - Remove the following items:
-
Refer to: Throttle Body (303-04 Fuel Charging and Controls - 2.5L Duratec-ST (VI5), Removal and Installation). -
Right-hand headlamp. Refer to: Headlamp Assembly (417-01A, Removal and Installation). | | | -
Refer to: Lifting (100-02, Description and Operation). | | | -
Refer to: Accessory Drive Belt (303-05 Accessory Drive - 2.5L Duratec-ST (VI5), Removal and Installation). | | | -
CAUTION:Make sure that the inside of the pipe ends are clean and free of oil residue. | | | -
WARNING:Be prepared to collect escaping fluid. CAUTION:Make sure that all openings are sealed. Use new blanking caps. NOTE:The O-ring seal is to be reused unless damaged. Torque: 23 Nm | | | -
NOTE:Install all the bolts finger tight before final tightening. | Installation | | -
To install, reverse the removal procedure. | | | -
Refer to: Power Steering System Filling (211-00 Steering System - General Information, General Procedures). | | |
