ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Engine Wiring Harness - 2.5L Duratec (VI5) > < Engine Wiring Harness - 1.6L Duratec-16V Ti-VCT (Sigma)

Mondeo 2007.5 (02.2007-)

Wiring Harnesses - Engine Wiring Harness—2.0L Duratec-HE (MI4)/2.3L Duratec-HE (MI4) Mondeo 2007.5 (02/2007-)
Removal and Installation

General Equipment
3.5 mm drill bit
Center punch

Removal

NOTE:
NOTE:Removal steps in this procedure may contain installation details.
  1. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
  1. Refer to: Air Cleaner (303-12B Intake Air Distribution and Filtering - 2.0L Duratec-HE (MI4)/2.3L Duratec-HE (MI4), Removal and Installation).
Vehicles with 2.0L engine
Vehicles with 2.3L engine
Vehicles built up to 09/2007
All vehicles
  1. Refer to: Lifting (100-04 Noise, Vibration and Harshness, Description and Operation).

  1. Right-hand headlamp.
    Refer to: Headlamp Assembly (417-01A Exterior Lighting, Removal and Installation).

Vehicles with 2.0L engine

Vehicles with 2.3L engine

All vehicles

  1. Torque: 10 Nm

  1. Torque: 10 Nm
  1. Remove the left-hand front wheel and tire.
    Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

Vehicles with PCM security shield
  1. Torque: 3 Nm

  1. General Equipment: Center punch
    General Equipment: 3.5 mm drill bit
All vehicles

Installation

  1. To install, reverse the removal procedure.
Vehicles with PCM security shield
  1. Tighten the shear bolt until the head is sheared off.

Engine Wiring Harness - 2.5L Duratec (VI5) > < Engine Wiring Harness - 1.6L Duratec-16V Ti-VCT (Sigma)