Mustang L4-140 2.3L SOHC (1982)
Figure 3
4.
Cut the sponge to approximately 7-3/4" x 2-1/8" x 1-5/8" and wrap it with a suitable plastic material such as a customer parts return bag or
household wrap (Figure 3, View A).
NOTE:
The sponge is used as a dam to prevent the Super Panel Filler from reaching the area where the pop up spring must be reinstalled.
Failure to wrap it with plastic will make it extremely difficult to remove when the filler expands and hardens.
5.
Insert the wrapped sponge into the hood latch hole and direct it to the left side until it reaches the pop up spring "U" nut (Figure 3, View B).
6.
Install the pop up spring and hood catch attaching bolts into the "U" nuts. Do Not install the spring and catch at this time (Figure 3, View B).
7.
Follow all instructions and cautions on the Super Panel Filler bag and prepare the filler for use.
8.
Squeeze the contents of the bag into the four holes in the hood as shown in Figure 3, View C. Use the entire bag, keeping the amount as equal as
possible in each hole.
9.
Allow a mimimum of 20 minutes for the material to expand and harden.