Mustang L4-140 2.3L VIN A 1-bbl (1983)
FIGURE 6
6.
If the gap is still evident, lower the quarter window and loosen the carrier in/outboard bolts to a snug condition (5-15 in.lbs. - Figure 5, Item C).
Raise the quarter window and position the division bar seal tight to the door glass. Lower quarter window and retighten the carrier in/outboard
bolts. (Torque to 60-70 in.lbs.) Raise the quarter window and recheck the seal.
7.
Cycle the quarter window and door glass a number of times verifying that cross-over does not exist. If cross-over exists, refer to Symptom "C".
8.
Reassemble following general adjustment sequence Steps 8 through 3 and steps in Symptom E.
Symptom:
B.
QUARTER GLASS GAPS THE ENTIRE LENGTH OF THE BACK EDGE OF THE DOOR GLASS.
