Mustang L4-140 2.3L VIN A 1-bbl (1983)
FIGURE 6
4.
Lower the quarter window and loosen the carrier in/outboard bolts to a snug condition (5-15 in.-lbs. - Figure 5, Item C). Raise the quarter window
and position the division bar seal tight to the door glass. Lower the window and tighten the bolts (60-70 in.lbs.).
5.
In the event that all the above adjustments do not completely correct the problem, the door glass must be readjusted by tilting outboard at the rear
edge.
6.
Cycle the quarter window and door glass a number of times to verify that cross-over will not occur.
7.
Reassemble following general adjustment sequence Steps 8 through 3 and Steps in Symptom E.
Symptom:
D.
DOOR GLASS HITS DIVISION BAR WHEN CLOSING THE DOOR.
