Mustang V6-232 3.8L (1985)
Figure 44
13.
Apply a 1/4 inch bead of Silicone Rubber Adhesive/Sealant, D6AZ-19562-B, around the weatherstrip tab edge.
Smooth and contour the sealer to match the weatherstrip tab.
Allow the sealer to dry before installing hatch on vehicle.
Figure 45
14.
Inspect the alignment between the hatch drip rail trim moulding and the same moulding on the body.
If the mouldings are out of alignment, adjust the latch guide plate.
