Mustang V6-232 3.8L (1985)
Air Duct: Customer Interest
Heater - Floor Duct Air Distribution Imbalance
Article No. 85-20-3
HEATER - IMPROVED FLOOR DUCT AIR DISTRIBUTION FOR VEHICLES BUILT BEFORE JULY 1, 1985
FORD 1985 THUNDERBIRD, LTD, MUSTANG
LINCOLN-MERCURY 1985 COUGAR, MARQUIS, CAPRI
Heated air distribution through the two outlets for the right-hand portion of the floor duct may be inadequately balanced on vehicles built before July 1,
1985. As a result, the floor area forward of the front passenger seat may be receiving a heavier than necessary flow of air through the large outlet in the
side of the duct and a passenger will experience excessive heat on one foot and not enough heat on the other.
Service Procedure
Figure 1 - SHEET METAL BAFFLE (ACTUAL SIZE)
1.
Using the template provided in Figure 1, make a sheet metal baffle from stock on hand or obtained locally. Cut the baffle and bend it along the
breaklines shown on the template.
Figure 2 - Baffle Positioning
2.
Refer to Figure 2. Position the baffle, as shown in the illustration, so that a 1/2 inch area along the right side of the right side outlet in the duct is
blocked.
3.
Attach the baffle with pop rivets or screws.
4.
Apply black tape over the baffle, as shown in Figure 2.
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual.
OPERATION: SP18433A85
