Water Leaks and Wind Noise in Convertible/T-Top Models (T-Top Technical Service Bulletins)
TEMPLATE 4LEFT "B" PILLAR
6.
Position template number three (3) to the right "B" pillar and template number four (4) to the left "B" pillar. Drill two (2) 9/32" holes in each "B"
pillar, Figure 3.
7.
Drill two (2) 1-1/8" holes 2-13/64" apart in each "B" pillar inner panel to provide access to install the door alignment pin catch plate, Figure 4.
Remove any sharp edges.
