Mustang V6-232 3.8L VIN 3 TBI (1984)
31. If equipped with air conditioning, install the compressor and mounting brackets. Tighten the attaching bolts to specification.
32. If equipped with power steering install the pump and mounting brackets. Tighten the attaching bolts to specification.
Timing Mark Alignment
33. Position the accessory drive belt over the pulleys.
34. Install the water pump pulley, fan/clutch assembly and fan shroud. Cross-tighten the fan/cutch assembly attaching bolts to 16-24 Nm (12-18 lb-ft).
CAUTION: Examine the fan for possible cracks, separation, oil damage before Installation. Replace the fan If necessary.
35. Position the fan shroud on the radiator and install the attaching screws.
36. Position the accessory drive belt over the water pump pulley and tension the belt.
37. Connect the cable to the battery negative terminal.
38. Fill the crankcase to the proper level with the specified oil.
39. Fill the cooling system with the specified coolant.
CAUTION: This engine has an aluminum cylinder head and requires a special unique corrosion Inhibited coolant formulation to avoid
radiator damage.
40. Start the engine and check for coolant, oil or fuel leaks.
41. Check the ignition timing and curb idle speed - adjust as required. Tighten distributor hold-down bolt 27-40 Nm (20-29 lb-ft).
42. Install the air cleaner assembly and air intake duct.
