Mustang V6-232 3.8L VIN 3 TBI (1984)
FIGURE 6
3.
Remove nipple from closure hole in rocker cover using a twisting action before pulling out, preferably with engine hot (See Figure 6, Step 1).
4.
Remove phillips head screws in throttle by-pass valve solenoid and rotate solenoid 180~ counterclockwise. DO NOT REMOVE SOLENOID OR
WIRE, then reinstall screws and torque to 22-26 lb.in. (See Figure 6, Step 2).
5.
Install oil separator (E4ZZ-6A785-A) after coating inlet nipple of oil separator with EOAZ-19554-B sealer or equivalent and tap down lightly with
rubber/nylon mallet.
6.
Install new connection-crankcase vent (E4ZZ- 6A668-B) in the turbocharger elbow (See Figure 6, Step 3).
7.
Install new closure tube vent (E4ZZ-6758-D) and new hose (381187-S040A) using old clips (See Figure 6, Step 4).
8.
Reinstall intercooler.
PART NUMBER
PART NAME
CLASS
E4ZZ-6A785-A
Oil Separator
C
E4ZZ-6A668-B
Crankcase Vent Connector
C
E4ZZ-6758-D
Closure Tube
C
