Mustang V6-3.8L VIN 4 (1998)
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
Engine Coolant Temperature (ECT) Sensor
REMOVAL
1. Partially drain engine cooling system.
2. Disconnect battery ground cable.
3. Disconnect fuel charging wiring from Engine Coolant Temperature sensor (ECT sensor).
4. Remove engine coolant temperature sensor from heater.
INSTALLATION
1. Follow removal procedure in reverse order.
2. Tighten engine coolant temperature sensor to 14-19 Nm (11-14 lb-ft).
3. Refill engine cooling system.
