Mustang V6-3.9L VIN 6 (2004)
7.
Attach the lower leg of the shield in an existing bolt hole by installing the bolt provided in the Kit.
8.
FOR CONVERTIBLES ONLY: Trap the shield between the X-brace and the crossmember. Tighten to 25 lb-ft (34 N.m).
9.
Reinstall the pushpin fasteners in the fender splash shield.
10.
Proceed to INSTALLATION OF THE CATALYST SYSTEM.
INSTALLATION OF THE CATALYST SYSTEM
1.
Install the catalyst system into the vehicle, using the isolator bracket at the transmission.
2.
Tighten the catalyst to the exhaust manifold fasteners to 30 lb-ft (41 N.m).
3.
Attach the muffler inlet pipe and tighten to 26 lb-ft (35 N.m).
4.
Check the system for grounding.
5.
Lower the vehicle.
6.
Reconnect the battery.
7.
Start the engine and check for exhaust leaks.
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage And Emissions Warranty Coverage
DEALER CODING
CONDITION
BASIC PART NO.
CODE
5H264
01
Disclaimer
