Mustang V6-4.0L (2008)
4. Open the valve on the bleeder tank.
5. Loosen the RH rear bleeder screw and leave open until clear, bubble-free brake fluid flows into the container. Wait 15 seconds after clear,
bubble-free fluid flows through the rubber hose.
6. Tighten the RH rear bleeder screw to 10 Nm (89 lb-in), remove the rubber hose and install the bleeder screw cap.
Vehicles equipped with a 4.0L SOHC or 4.6L (3V) engine
7. Continue bleeding the system in the following sequence:
1
LH rear brake caliper bleeder screw
^
Tighten to 10 Nm (89 lb-in).
2
RH front brake caliper bleeder screw
^
Tighten to 10 Nm (89 lb-in).
3
LH front brake caliper bleeder screw
^
Tighten to 10 Nm (89 lb-in).
Vehicles equipped with a 5.4L engine
8. Continue bleeding the system in the following sequence:
1
LH rear brake caliper bleeder screw
^
Tighten to 10 Nm (89 lb-in).
2
RH front brake caliper inner bleeder screw
^
Tighten to 18 Nm (13 lb-ft).
3
RH front brake caliper outer bleeder screw
^
Tighten to 18 Nm (13 lb-ft).
4
RH front brake caliper inner bleeder screw
^
Tighten to 18 Nm (13 lb-ft).
5
LH front brake caliper inner bleeder screw
^
Tighten to 18 Nm (13 lb-ft).
6
LH front brake caliper outer bleeder screw
^
Tighten to 18 Nm (13 lb-ft).
7
LH front brake caliper inner bleeder screw
^
Tighten to 18 Nm (13 lb-ft).
All vehicles
9. Close the bleeder tank valve. Remove the tank hose from the adapter and remove the adapter.
10. Inspect the brake fluid level in the master cylinder reservoir.
^
Fill the brake master cylinder reservoir with clean, specified brake fluid if necessary.
11. Install the brake master cylinder filler cap.
