Mustang V6-4.0L VIN N (2006)
2.
Position a jack stand underneath the catalytic converter Y-Pipe I H-Pipe.
3.
Adjust the height of the catalyst using the jack stand to achieve the 2" +/- 0.5" (50 mm +/- 13 mm) clearance between the exhaust pipe and floor
pan (behind the catalytic converter).
4.
Evenly tighten all four (4) catalytic converter-to-exhaust manifold nuts (starting with the right lower, then the left lower, then the right upper, then
the left upper) in 7 lb-ft (10 N.m) increments to a final torque of 33 lb-ft (45 N.m).
5.
Verify that the nuts on the coupler between the intermediate pipe and catalytic converter are torqued to 40 lb-ft (54 N.m).
OTHER APPLICABLE ARTICLES: 05-8-6
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
080304A
2005-2008 Mustang built
0.3 Hr.
Before 12/03/2007:
Remove The Exhaust
Isolator Mounts, Adjust
The Exhaust Hanger Rod
And, Verify Exhaust
System Is Properly Aligned
Following Service
Procedure (Do Not Use
With 5200A, 5229A)
080304B
2005-2008 Mustang built
0.5 Hr.
Before 12/03/2007:
Remove The Exhaust
Isolator Mounts, Adjust
The Exhaust Hanger Rod,
Verify Exhaust System Is
Properly Aligned And,
Perform Exhaust System
Alignment Following
Service Procedure (Do Not
Use With 5200A, 5229A)
DEALER CODING
CONDITION
BASIC PART NO.
CODE
6A023
07
Disclaimer
