Mustang V6-4.0L VIN N (2006)
5. Slide the SJB downward and position the SJB forward to access the rear electrical connectors.
6. Disconnect the 6 rear SJB electrical connectors
7. Remove the SJB.
8. CAUTION: Make sure that the wiring harnesses are correctly routed. Pinching the wiring harnesses between the SJB and the mounting
surface may cause damage to the wiring harness.
NOTE: Do not remove the watershield from the new SJB.
To install, reverse the removal procedure.
-
Download the module configuration information from the diagnostic tool into the new module.
