Mustang V6-4.0L VIN N (2006)
Fluid Filter - A/T: Service and Repair
Transmission Fluid In-Line Filter
Transmission Filter - In Line
Material
NOTE: Use the following guidelines for installing the transmission fluid in-line filter:
-
If the transmission was overhauled and the vehicle was equipped with an in-line fluid filter, install a new in-line fluid filter.
-
If the transmission was overhauled and the vehicle was not equipped with an in-line fluid filter, install a new in-line fluid filter kit.
-
If the transmission is being installed for a non-internal repair, do not install an in-line filter or filter kit.
-
If installing a new or a Ford-authorized remanufactured transmission, install the in-line transmission fluid filter that is supplied.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Cut a section of the upper transmission fluid cooler hose to allow installation of the transmission fluid in-line filter.
3. CAUTION: The filter has a bypass valve in it. The red arrow on the filter indicates the direction of the fluid flow through the filter. The
filter must be installed in the fluid cooler return line with the red arrow on the filter pointing away from the transmission fluid cooler and
toward the transmission (the return line has fluid coming out of the cooler going to the transmission). If the fluid filter is not installed
correctly, it will cause internal transmission damage.
CAUTION: Do not install any rubber hoses or steel tubing with a bend entering the filter greater than 60°.
Install the one end of the filter into the rubber hose with a clamp, then install the other end of the filter into the rubber hose.
-
Install and tighten the 2 hose clamps.
