Mustang V8-302 5.0L CFI HO (1985)
Figure 64
20.
If necessary because holes don't line up, using the holes in the weatherstrip as a guide, center punch and drill 1/8 inch holes in the door panels.
21.
Attach the weatherstrip to the door outer panel using a 1/8 inch small head blank rivet.
22.
Attach the weatherstrip to the door side and inner panels using 1/8 inch large head blank rivets.
Figure 65
23.
Tap the beltline moulding back into place using a block of wood and plastic tipped hammer.
Door Lower Opening
NOTE:
This procedure is to be performed if the door upper opening/hatch weatherstrip is long enough to meet the lower door weatherstrip.
