Mustang V8-302 5.0L CFI HO (1985)
13. Install the fuel pump using a new gasket. Connect the fuel pump outlet line.
14. Connect the radiator hose, heater hose and water pump by pass hose at the water pump.
15. Install all the accessory brackets which attach to the water pump. Place the water pump pulley on the water pump shaft.
16. Install the power steering pump and drive belt if so equipped. Install the alternator and drive belt. Install the air conditioner idler pulley bracket
and drive belt if so equipped.
17. Position the fan shroud over the water pump pulley and install the spacer or fan drive clutch and fan. Install the shroud attaching bolts. Install the
carburetor air inlet tube.
Adjust the drive belts to the specified belt tension.
18. Fill and bleed the cooling system. Operate the engine until normal operating temperatures have been reached and check for leaks.
19. Fill the crankcase with the proper grade and quantity of engine oil.
20. Fill and bleed the cooling system.
21. Operate the engine at fast idle and check for coolant and oil leaks. Check and adjust the ignition timing and engine idle speed.
