Mustang V8-302 5.0L COBRA (1995)
Brake Master Cylinder: Service and Repair
REMOVAL
1. Remove the brake tubes from the primary and secondary outlet ports of the master cylinder and brake pressure control valve.
2. Remove two nuts retaining master cylinder to the booster assembly.
3. Disconnect brake fluid level indicator electrical connector.
4. Slide master cylinder forward and upward from vehicle.
INSTALLATION
1. Position master cylinder assembly over booster push rod and onto two studs on the booster assembly.
2. Install the retaining nuts.
3. Install the brake tubes to the master cylinder and brake pressure control valve.
4. Connect reservoir cap.
5. Fill reservoir to MAX line with brake fluid.
6. Perform system brake bleeding procedures.
7. Operate brakes several times, and check for external hydraulic leaks.
