Mustang V8-302 5.0L COBRA (1995)
7.
Drill two (2) 5.0 mm holes per Figure 1.
NOTE:
THE HOLES MUST PASS THROUGH THE CENTER CONSOLE SUPPORT, FLOOR PAN, AND PARKING BRAKE CABLE BRACKET.
CAUTION:
CARE MUST BE TAKEN WHEN DRILLING TO AVOID SNAGGING THE INTERIOR CARPETING ABOVE THE HOLES. USE A DRILL
DEPTH LIMITER TO RESTRICT ITS PENETRATION TO 6 mm (1/4").
8.
Install two (2) 3/16" Rivets (N808594-S100) per Figure 1.
9.
Drill one (1) 5.0 mm hole approximately 146 mm (5.75") rearward of the parking brake cable bracket centered above where the driveshaft would
be located. Refer to Figure 1 for rivet hole location.
10.
Reinstall parking brake cable and equalizer.
11.
With the brake cable conduits in position, place the Support Bracket (F5ZZ-2B622-AC) over the brake cable conduits and Rivet (353016-S) it to
