Mustang V8-302 5.0L COBRA (1995)
4.
Remove the constant control relay module (CCRM) from the upper radiator support and position it out of the way. See Figure 2.
5.
Disconnect and remove the front airbag impact sensor from the vehicle. See Figure 2.
6.
On 3.8L-equipped models, remove the wiring harness from the cooling fan shroud.
7.
Remove the two (2) fasteners securing the cooling fan and shroud assembly to the radiator, then remove the assembly from the vehicle. If
equipped, do not remove the electronic circuit breaker module installed as part of Safety Recall 01S30, or the jumper harness installed as part of
Safety Recall 97S66 or 95S22. See Figure 3.
8.
Position the new cooling fan and shroud assembly into the vehicle.
9.
Install the two (2) fasteners securing the cooling fan and shroud assembly to the radiator. Tighten the bolts to 3 N.m (28 lb-in) and the nuts to 10
N.m (88 lb-in).
10.
On 3.8L-equipped models, install the wiring harness onto the cooling fan shroud.
11.
Install the front airbag impact sensor into the vehicle and connect the electrical connector. Tighten the bolts to 10 N.m (88 lb-in).
12.
Install the CCRM to the upper radiator support. Tighten the bolts to 10 N.m (88 lb-in).
13.
Connect the cooling fan electrical connector.
14.
If equipped, position the radiator upper sight shield onto the vehicle and install the fasteners.
15.
Connect the battery negative cable and set radio stations.
16.
Check cooling fan operation.
Mustang 3.8L and 5.0L H0
1.
Record preset radio stations, then disconnect the battery negative cable.
2.
If equipped, remove the radiator upper sight shield from the vehicle.
