Mustang V8-302 5.0L COBRA (1995)
specification ESR-M18P2-A and ESE-M4GI 15-A on the engine front cover.
Install the water pump.
3. Install the retaining bolts and stud bolts. Tighten to 20-28 Nm (15-21 lb-ft).
4. Connect the lower radiator hose, heater water hose and water bypass hose at the water pump.
5. Install all the accessory brackets which attach to the water pump. Install the water pump pulley.
6. Install the drive belt.
7. Install the cooling fan motor, fan blade and fan shroud as an assembly. Refer to Engine, Cooling, and Exhaust/Cooling System/Cooling Fan Motor.
See: Cooling System/Radiator Cooling Fan/Electric Cooling Fan Motor/Service and Repair
8. Connect cooling fan motor to headlamp dash panel junction wire.
9. Fill and bleed the engine cooling system.
10. Operate the engine until normal operating temperatures have been reached and check for leaks.
