Mustang V8-302 5.0L COBRA (1995)
4.
On 3.8L-equipped models, remove the wire harness from the cooling fan shroud.
5.
Remove the two (2) fasteners securing the cooling fan and shroud assembly to the radiator, then remove the assembly from the vehicle. If
equipped, do not remove the jumper harness installed as part of Safety Recall 97S66 or 95S22.
6.
Position the new cooling fan and shroud assembly into the vehicle.
7.
Install the two (2) fasteners securing the cooling fan and shroud assembly to the radiator.
Tighten the bolts to 3 Nm (28 lb-in) and the nuts to 10 Nm (88 lb-in).
8.
On 3.8L-equipped models, install the wire harness onto the cooling fan shroud.
9.
Install the front airbag impact sensor into the vehicle and connect the electrical connector.
Tighten the bolts to 10 Nm (88 lb-in).
10.
Install the CCRM to the upper radiator support.
Tighten the bolts to 10 Nm (88 lb-in).
11.
Connect the cooling fan electrical connector.
12.
If equipped, position the radiator upper sight shield onto the vehicle and install the fasteners.
13.
Connect the battery negative cable and set radio stations.
14.
Check cooling fan operation.
Mustang 3.8L and 5.0L H0
1.
Record radio preset stations, then disconnect the battery negative cable.
2.
Disconnect the coolant recovery reservoir hose from the radiator fill neck, then disconnect the coolant recovery reservoir electrical connector.
Remove the bolt attaching the reservoir to the bracket.
3.
Remove the reservoir bracket from the upper radiator support and position it out of the way. Then remove the reservoir from the vehicle.
4.
Disconnect the two (2) wire harness electrical connectors located on the right side of the radiator. See Figure 10.
5.
Remove the two (2) fasteners securing the cooling fan and shroud assembly to the radiator, then remove the module from the vehicle.
6.
Position the new cooling fan and shroud assembly into the vehicle.
7.
Install the two (2) fasteners securing the cooling fan and shroud assembly to the radiator.
