Mustang V8-302 5.0L COBRA (1995)
Ignition Coil: Service and Repair
Ignition Coil
REMOVAL
1. Disconnect engine control sensor wiring at radio ignition interference capacitor and ignition coil connector.
2. Disconnect ignition wire at ignition coil.
Ignition Coil, Bracket And Radio Ignition Interference Capacitor
3. Remove ignition coil-to-ignition coil mounting bracket retaining screws and remove ignition coil.
4. If required, remove radio ignition interference capacitor from ignition coil.
INSTALLATION
1. To install, reverse Removal procedure.
2. Tighten ignition coil retaining screws to 2.8-4.0 Nm (25-35 in lb). Tighten retaining screw for radio ignition interference capacitor to 2.8-4.0 Nm
(25-35 in lb).
