Mustang V8-302 5.0L COBRA (1995)
Distributor Cap: Service and Repair
REMOVAL
1. Note the location and remove ignition wires from distributor cap as required. Loosen distributor cap hold-down screws.
2. Remove distributor cap straight off distributor to prevent damage to distributor rotor blade and spring.
INSTALLATION
1. Position distributor cap on distributor base noting the square alignment locator. Tighten hold-down screws to 2.0-2.6 Nm (18-23 in lb).
2. Install any ignition wires that were removed, noting their correct locations on the distributor cap.