Mustang V8-302 5.0L HO (1987)
Clutch Disc: Service and Repair
1. Lift clutch pedal upward to disengage clutch cable self adjuster pawl and quadrant. Push quadrant forward, then detach cable from quadrant and
allow quadrant to swing rearward slowly.
2. Position gear shift lever in neutral, then remove lever attaching screws and the lever.
3. Raise and support vehicle.
4. Remove dust shield.
5. Remove driveshaft. Cover extension housing to prevent leakage.
6. Disconnect electrical leads and speedometer cable from transmission.
7. Support rear of engine and remove crossmember, then lower engine as necessary and remove transmission attaching bolts and transmission.
8. Disconnect clutch release cable from lever and flywheel housing.
9. Disconnect starter cable and remove starter motor.
10. Remove flywheel housing.
11. Evenly loosen and remove pressure plate attaching screws to prevent distortion of pressure plate. If pressure plate is to be reused, mark pressure
plate and flywheel to assure correct assembly.