Mustang V8-4.6L (2009)
bow. Use a small punch to knock out the rivet slug and clear the hole.
Installation
1. Open the convertible top as necessary to rivet new cable flag to convertible top frame No. 1 bow.
2. Pull the cable sheathing upward, approximately 15.25 cm (6 in) from the cable eyelet and position the cable into the cable guide.
3. NOTE: Save the sound isolation webbing from the old cable spring so it can be transferred to the new cable spring.
Pull the old cable through the cable guide and route the new cable through the cable guide.
4. Put the sound isolation material on the new cable spring and rivet new cable to convertible top frame No. 5 bow.
5. Install the 2 Torx screws and the front weatherstrip retainer channel.
6. Install the front weatherstrip.
-
Install the 2 pushpins.
