Mustang V8-4.6L (2009)
9. Remove the bolt and position the LH camshaft sprocket aside.
Both sides
10. NOTE: Mark the position of the camshaft bearing caps so they can be installed in their original positions.
Remove the bolts in the sequence shown and remove the camshaft bearing caps.
11. Remove the camshaft.
Installation
Both sides
1. NOTE: Lubricate the camshafts with clean engine oil.
Install the camshaft.
2. NOTE: Lubricate the camshaft bearing caps with clean engine oil.
NOTE: The camshaft bearing caps must be installed in their original positions.
NOTE: After installing the bolts, check the camshaft for free rotation.
Install the camshaft bearing caps and the bolts.
-
Tighten the bolts in the sequence shown in 2 stages.
-
Stage 1: Tighten to 6 Nm (53 lb-in).
-
Stage 2: Tighten to 16 Nm (142 lb-in).
RH side
