Mustang V8-4.6L (2009)
Removal
NOTICE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while
cleaning gasket surfaces that enters the oil passages, coolant passages or the oil pan, can cause engine failure.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. Remove the Throttle Body (TB).
4. Remove the Front End Accessory Drive (FEAD) bracket bolt and install the Engine Lifting Bracket.
5. Remove the 8 pin-type retainers and the radiator sight shield.
6. Install the Engine Support Bar.