Mustang V8-4.6L (2009)
20. Remove the retaining clip from the RH timing chain tensioner.
21. NOTE: The RH and LH camshaft phaser sprockets are similar. Refer to the single timing mark to identify the RH camshaft phaser sprocket and
the L timing mark to identify the LH camshaft phaser sprocket.
As a post-check, verify correct alignment of all timing marks. Make sure the timing marks on the sprockets correspond to the above note.
22. Install the crankshaft sensor ring on the crankshaft.
23. NOTE: It is necessary to rotate the engine to position the camshaft lobes at base circle to install the roller followers.
Using the Valve Spring Compressor, install all of the camshaft roller followers.
-
Lubricate the roller followers with clean engine oil prior to installation.
