Mustang V8-4.6L (2009)
9. Install the 2 LH catalytic converter-to-exhaust manifold nuts.
-
Tighten to 40 Nm (30 lb-ft).
10. Install the 2 RH catalytic converter-to-exhaust manifold nuts.
-
Tighten to 40 Nm (30 lb-ft).
11. Connect the LH HO2S electrical connector and wiring retainer.
12. NOTE: Make sure the B+ cable is positioned close to the generator when the nut is being tightened.
Position the generator and install the B+ terminal and nut.
-
Tighten to 8 Nm (71 lb-in).
13. Connect the generator electrical connector and pin-type retainers.
14. Install the 2 lower generator nuts.
-
Tighten to 25 Nm (18 lb-ft).
15. Install the 2 outer generator bracket bolts.
-
Tighten to 10 Nm (89 lb-in).
16. Using a suitable belt tensioner release tool, rotate the accessory drive belt tensioner clockwise and position the accessory drive belt onto the
generator pulley.
17. Install the radiator sight shield and 6 pin-type retainers.
18. Install the TB.
19. Install the ACL assembly.
20. Connect the battery ground cable.
Exhaust Manifold - RH
Exhaust Manifold - RH
