Mustang V8-4.6L (2009)
4. Install the RH engine support insulator bracket, the 2 bolts and 2 stud bolts.
-
Tighten to 55 Nm (41 lb-ft).
5. If equipped, install the transmission cooler tube bracket and nut.
-
Tighten to 25 Nm (18 lb-ft).
6. Install the ground wire and nut onto the stud bolt.
-
Tighten to 25 Nm (18 lb-ft).
7. Using the Engine Support Bar, lower the engine.
8. If equipped, install the strut tower cross brace and the 4 nuts.
-
Tighten to 35 Nm (26 lb-ft).
9. NOTE: RH shown, LH similar.
Install the RH and LH engine support insulator nuts.
-
Tighten to 63 Nm (46 lb-ft).
10. Install the 2 LH catalytic converter-to-exhaust manifold nuts.
-
Tighten to 40 Nm (30 lb-ft).
