Mustang V8-4.6L (2009)
Air Bag Deactivation Indicator: Service and Repair
Passenger Air Bag Deactivation (PAD) Indicator
NOTE: The Passenger Air Bag Deactivation (PAD) indicator is part of the Hazard/Traction control switch assembly.
1. NOTE: The Ignition must be in OFF position if disconnecting the PAD indicator electrical connector. Otherwise, a DTC will be set in the
Restraints Control Module (RCM) memory and must be cleared before releasing the vehicle.
Turn the ignition the OFF and wait at least one minute.
2. Remove the instrument panel center finish panel.
3. Release the 4 tabs (2 upper and 2 lower) on the PAD indicator and remove it from the instrument panel center finish panel.
4. To install, reverse the removal procedure.
5. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Dashboard /
Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering and Repowering in the
General Procedures.