ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2558 > < Initial Inspection and Diagnostic Overview|Page 2556
Page 41
background image

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to K19.

No

GO to K16.

-------------------------------------------------
K16 VERIFY VEHICLE EQUIPMENT - ABS MODULE

-

Inspect the vehicle for an ABS module.

-

Is the vehicle equipped with an ABS module?

Yes

GO to K17.

No

GO to K18.

-------------------------------------------------
K17 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE ABS MODULE DISCONNECTED

-

Disconnect: ABS Module C135.

-

Measure the resistance between the DLC C251-6, circuit 1827 (WH/LG), harness side and ground; and between the DLC C251-14, circuit 1828
(PK/LG), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT all modules. CONNECT the negative battery cable. GO to K20.

No

GO to K18.

-------------------------------------------------
K18 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE IC DISCONNECTED

-

Disconnect: IC C220.

-

Measure the resistance between the DLC C251-6, circuit 1827 (WH/LG), harness side and ground; and between the DLC C251-14, circuit 1828
(PK/LG), harness side and ground.

Initial Inspection and Diagnostic Overview|Page 2558 > < Initial Inspection and Diagnostic Overview|Page 2556