Mustang V8-4.6L (2009)
Engine Control Module: Removal and Replacement
Powertrain Control Module (PCM)
Removal
1. NOTE: Any PCM replacement will require that ALL customer keys are available to be programmed at the time of installation. PCM replacement
DOES NOT require new keys.
Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation (PMI) procedure.
2. Disconnect the 3 PCM electrical connectors.
3. Remove the 2 bolts and the PCM.
Installation
1. Install the PCM and the 2 bolts.
-
Tighten to 8 Nm (71 lb-in).
2. Connect the 3 PCM electrical connectors.
3. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation (PMI) procedure.
4. Reprogram the Passive Anti-Theft System (PATS). Carry out the Key Programming Using Two Programmed Keys procedure. See: Accessories
and Optional Equipment/Antitheft and Alarm Systems/Testing and Inspection/Programming and Relearning/Key Programming Using Two
Programmed Keys