Mustang V8-4.6L (2009)
Throttle Body: Service and Repair
Throttle Body
Removal and Installation
1. Remove the Air Cleaner (ACL) outlet pipe.
2. Disconnect the Throttle Position (TP) sensor electrical connector.
3. Disconnect the electronic throttle control electrical connector.
4. NOTE: Discard the Throttle Body (TB) gasket.
Remove the 2 stud bolts, 2 nuts and the TB.
-
To install, tighten to 10 Nm (89 lb-in).
5. NOTE: Install a new TB gasket.
To install, reverse the removal procedure.
