Mustang V8-4.6L (2009)
Ignition Coil: Service and Repair
Ignition Coil-On-Plug
Ignition Coil-On-Plug
Removal and Installation
1. Disconnect the 8 ignition coil electrical connectors.
2. Remove the 8 ignition coil bolts.
-
To install, tighten to 6 Nm (53 lb-in).
3. NOTE: When removing the ignition coils, a slight twisting motion will break the seal and ease removal.
Remove the 8 ignition coils.
4. To install, reverse the removal procedure.
-
Apply a light film of brake caliper grease to the inside of the coil boots before installation.
