Mustang V8-4.6L (2009)
Engine Temperature Sensor: Service and Repair
Cylinder Head Temperature (CHT) Sensor - 4.6L (3V)
Removal and Installation
1. Release the fuel system pressure.
2. Disconnect the battery ground cable.
3. Remove the intake manifold.
4. Disconnect the Cylinder Head Temperature (CHT) sensor electrical connector.
5. Remove and discard the CHT sensor.
-
To install, tighten to 10 Nm (89 lb-in).
6. To install, reverse the removal procedure.
-
Do not reuse the CHT sensor. Install a new sensor.
