Mustang V8-4.6L (2009)
2. Install the door disarm switch.
-
The door disarm switch mark must be positioned towards the harness side of the switch prior to installation.
3. Install the lock cylinder actuator pawl.
4. The E-clip must be positioned with the arc pointing towards the door lock cylinder to ensure the proper tension is applied toward the door disarm
switch or the switch may not seal properly. Install the E-clip.
5. Install the door disarm switch wiring harness retainer on the post on the LH door latch.
6. Connect the door disarm switch electrical connector.
7. Position the watershield.
8. Install the LH front door trim panel.
