Mustang V8-4.6L (2009)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position (CKP) Sensor - 4.6L (3V)
Removal and Installation
1. With vehicle in NEUTRAL, position it on a hoist.
2. Remove the accessory drive belt.
3. Detach the wiring harness retainers from the A/C compressor stud bolts.
4. Disconnect the A/C compressor field coil and the Crankshaft Position (CKP) sensor electrical connectors.
5. Remove the stud bolts and position the A/C compressor aside.
-
To install, tighten to 25 Nm (18 lb-ft).
6. Remove the CKP sensor bolt and sensor.
-
To install, tighten to 10 Nm (89 lb-in).
7. To install, reverse the removal procedure.
