Mustang V8-4.6L (2009)
Seats with power
7. Disconnect the seat control switch electrical connector from the cushion side shield.
All seats
8. NOTE: Note position of wire harness routing for installation.
Release all the seat wire harness routing clips and electrical connector retainers from the seat cushion frame.
Seats with an OEM Occupant Classification Sensor (OCS)
9. Release the 2 OCS system bladder pin-type retainers and separate it from the seat cushion frame.
All seats
10. Remove the rivets and separate the OCSM from the seat cushion frame bracket.
11. NOTE: Note position of hose routing for installation.
Remove the OCS system from the seat cushion frame assembly.
-
Feed the hose, pressure sensor, wire harness, electrical connector and OCSM through the opening in the seat cushion frame.
Installation
All seats
1. WARNING: Install a new occupant classification sensor (OCS) system service kit as a complete assembly. Never install only part of the
kit components. Failure to follow this instruction may result in incorrect operation of the OCS system and increases the risk of serious
personal injury or death in a crash.
NOTICE: Failure to route the seat Occupant Classification Sensor (OCS) system components through the correct seat cushion support
opening may cause component failure.
NOTICE: While positioning the seat cushion frame and Occupant Classification Sensor (OCS) system assembly, be careful not to damage
any of the components. Failure to do so may result in component failure.
Position the OCS system components to the seat cushion frame as noted during removal.
-
Feed the hose, pressure sensor, wire harness, electrical connector and the OCSM through the seat cushion frame.
