Mustang V8-4.6L (2009)
11. Connect the Transmission Fluid Fill Tool and the Fluid Transporter/Evacuator/Injector.
-
Connect the open end of the fluid hose from the Fluid Transporter/Evacuator/Injector to the Transmission Fluid Fill Tool at the bottom of the
transmission fluid pan.
12. Apply a maximum of 206.85 kPa (30 psi) to the open end of the vacuum/pressure hose from the Rubber Tip Air Nozzle. Transmission fluid will
immediately start flowing out of the Fluid Transporter/Evacuator/Injector into the transmission fluid pan.
13. Add one pint of transmission fluid into the transmission fluid pan. Stop the process by releasing the air pressure and removing the Rubber Tip Air
Nozzle from the end of the hose.
14. Inspect the transmission fluid level in the Fluid Transporter/Evacuator/Injector. If the transmission fluid drains back into the canister, the
transmission is full. If no transmission fluid drains back, more transmission fluid will need to be added. Repeat Steps 12 and 13.
15. Once the transmission is full, place a hand vacuum pump from the Vacuum Pump Kit on the open end of the vacuum/pressure hose of the Fluid
Transporter/Evacuator/Injector and apply vacuum to the system. This will pull out any extra transmission fluid trapped in the system and direct it
into the container.
16. Allow the transmission fluid to drain. Make sure that the transmission fluid temperature is between 27°-49°C (80°-120°F). When the transmission
fluid comes out as a thin stream or drip, the transmission fluid is at the correct level.
17. Reinstall the transmission fluid pan drain plug (short hex).
-
Tighten to 10 Nm (89 lb-in).
