Mustang V8-4.6L (2009)
7. Using the Torque Converter Fluid Seal Remover and Slide Hammer, remove and discard the extension housing seal.
Installation
1. NOTE: Make sure the extension housing seal is correctly installed onto the Drive Pinion Oil Seal Installer and the garter spring is in the correct
position.
Using the Drive Pinion Oil Seal Installer, install the new extension housing seal.
2. Using the Output Shaft Flange Installer and the Drive Pinion Flange Installer, install the output flange.
3. Install a new transmission output shaft flange nut.
-
Tighten to 130 Nm (96 lb-ft).
4. Install the 4 transmission crossmember-to-floor pan screws only.
-
Tighten to 63 Nm (46 lb-ft).
