Mustang V8-4.6L (2009)
1. For additional information, refer to the procedures.
Flywheel
Flywheel
Removal
1. Remove the clutch.
2. Remove the 6 flywheel bolts.
3. NOTICE: The flywheel has a pressed fit on the crankshaft pilot. Do not use screwdrivers or prybars to remove the flywheel or damage to
the flywheel or engine may occur.
Remove the flywheel.
-
Install 2 of the removed flywheel bolts in the 2 holes shown on the flywheel flange.
-
Tighten the 2 bolts evenly to push the flywheel off the crankshaft pilot.
Installation
1. Position the flywheel on the crankshaft pilot and start the 6 flywheel bolts.
2. Tighten the flywheel bolts evenly in the sequence shown to fully seat the flywheel on the crankshaft pilot.
-
Tighten to 80 Nm (59 lb-ft).
Flywheel/Flexplate Oil Pan and Crankshaft Rear Seal - Exploded View
