Mustang V8-4.6L DOHC (1996)
13. NOTE: Camshaft Positioning Tool T93P-6256-A must be installed on camshafts to prevent camshafts from rotating.
Remove camshaft sprocket retaining bolts.
14. CAUTION: Secondary timing chain tensioner plunger is spring-loaded. Care must be taken to prevent plunger from dropping out of timing chain
tensioner during disassembly.
Compress secondary timing chain tensioners and lock the timing chain tensioner in the compressed position using clip. Remove secondary timing
chain and camshaft sprockets.
15. Remove secondary timing chain tensioner.
16. CAUTION: Failure to use camshaft torquing tool while removing or tightening camshaft bolts may result in damage to camshaft D-slots or
Camshaft Positioning Tool T93P-6256-A.
Remove two bolts retaining LH primary timing chain tensioner to cylinder head and remove primary timing chain tensioners.
17. Remove bolt retaining LH timing chain tensioner arm and remove LH timing chain tensioner arm.
18. Remove three bolts retaining LH timing chain guide and remove timing chain guide.
19. Remove LH primary timing chain from camshaft sprocket and crankshaft sprocket.
20. If necessary, remove primary or secondary camshaft sprockets or secondary timing chain tensioners with Camshaft Holding Tool T93P-6256-AH
at center area of camshafts.
21. Remove camshaft sprocket retaining bolts.
22. CAUTION: Secondary timing chain tensioner plunger is spring-loaded. Care must be taken to prevent plunger from dropping out of timing chain
tensioner during disassembly.
Compress secondary chain tensioner and lock the chain tensioner in the compressed position using clip. Remove secondary timing chain and
camshaft sprockets.
23. CAUTION: Do not rotate crankshaft and/or camshafts or engine damage may occur.
NOTE: Camshaft Holding Tool T93P-6256-AH and Camshaft Positioning Tool T93P-6256-A or equivalent must be installed on camshafts to
prevent camshafts from rotating.
Inspect friction material on timing chain tensioner arms and timing chain guides. If worn or damaged remove and clean oil pan (6675) and replace
oil pump screen cover and tube (6622).
