Mustang V8-4.6L DOHC VIN R (2003)
4.
Install four (4) of the 1.5 mm-thick washers (8 included in kit with a 12.1- 12.4 mm I.D.) between the seat backrest bracket and the seat bottom
cushion frame (Figure 2).
5.
Install other four (4) of the 1.5 mm-thick washers between the seat backrest latch and the seat backrest frame at the upper bolt location (Figure 1).
6.
Install the three (3) 2 mm thick washers (smaller I.D.) between the seat backrest latch and the seat backrest frame at the lower bolt location (Figure
1).
7.
Using the bolt that is provided in the kit for the lower hole, Re-install the seat backrest latch using the reverse of the procedure listed in Section
501-10.
8.
Re-install the seat backrest using the reverse of the procedure listed in Section 501-10.
9.
Re-install seat into vehicle using the reverse of the procedure listed in Section 501-10. Slide seat towards center console before tightening seat to
floor.
10.
Verify that seat does not touch door panel.
Parts Block
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage
OPERATION
DESCRIPTION
TIME
030105A
Install Shims To Move
0.8 Hr.
Seat Away From Door
Trim Panel (Includes Time
To Remove And Install
Seat)
DEALER CODING
CONDITION
BASIC PART NO.
CODE
7661018
07
OASIS CODES: 101000, 107000, 702000, 702300