ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Air Bag Control Module|Removal and Installation|Page 6472 > < Air Bag Control Module|Removal and Installation|Page 6470
Page 3
background image

2. Install the RCM.

1

Install the bolt.

2

Reposition the carpet.

3. Connect the battery ground cable.
4. With the restraint system diagnostic tools installed at all deployable devices, prove out the supplemental restraint system (SRS).  See: Air Bag

Systems/Air Bag(s) Arming and Disarming/Service and Repair/Prove Out Procedure

5. Disconnect the battery ground cable and wait at least one minute.
6. Restore the vehicle to operating condition. Refer to Air Bag(s) Arming and Disarming.

1

Reactivate the supplemental restraint system (SRS). Refer to Air Bag(s) Arming and Disarming.

WARNING:  TO REDUCE THE RISK OF SERIOUS PERSONAL INJURY, READ AND FOLLOW ALL WARNINGS,
CAUTIONS, NOTES, AND INSTRUCTIONS IN THE SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
DEACTIVATION/REACTIVATION PROCEDURE.

2

With all the restraint system diagnostic tools removed, prove out the supplemental restraint system (SRS).  See: Air Bag Systems/Air Bag(s)
Arming and Disarming/Service and Repair/Prove Out Procedure

WARNING:  THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE
FROM THE VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE
VIOLATION OF VEHICLE SAFETY STANDARDS.

Air Bag Control Module|Removal and Installation|Page 6472 > < Air Bag Control Module|Removal and Installation|Page 6470