Mustang V8-4.6L DOHC VIN R (2003)
5. Remove all four of the snap rings.
6. NOTE: If necessary, use a pair of pliers to remove a bearing cup if it cannot be pressed out all the way.
Remove the driveshaft slip yoke.
1
Position the driveshaft slip yoke in the U-joint tool.
2
Press out a bearing cup.
3
Rotate the driveshaft slip yoke.
4
Press on the spider to remove the remaining bearing cup.
5
Remove the driveshaft slip yoke.
7. Repeat Step 5 to remove the remaining bearing cups and spider from the driveshaft.
8. Clean the yoke area at each end of the driveshaft.
Assembly
1. NOTE: Universal joint service kits are to be installed as complete assemblies only. Do not mix components from other U-joint kits.
