Mustang V8-4.6L SC VIN Y (2004)
7. CAUTION: The parking brake lever pin retainer clip and spring cover are spring-loaded. Use care when removing the parking brake lever pin
retainer clip.
Remove the parking brake lever pin retainer clip.
^
Unload the spring tension from the parking brake lever pin retainer clip and spring cover using Screw and Cross Block, a 6-mm washer head
nut and a 1/2-inch drive 14-mm socket.
^
Remove the parking brake lever pin retainer clip with suitable snap-ring pliers.
^
Remove Screw and Cross Block.
8. Remove the following components:
1
spring cover
2
spring
3
washer
4
key plate
5
push rod
6
strut pin
7
push rod O-ring
9. Remove and discard the O-ring seal from the push rod.
10. Remove the parking brake lever.
1
Remove the parking brake return spring:
2
Remove the limiting bolt.
3
Remove the parking brake lever.
4
Remove the parking brake lever shaft seal from the caliper bore.
Assembly
1. CAUTION: Do not reuse piston seals or dust boots.
