Mustang V8-4.6L SC VIN Y (2004)
Evaporative System Service Port: Service and Repair
EVAPORATIVE EMISSION TEST PORT
REMOVAL
1. Disconnect the pin-type retainer.
2. Raise and support the vehicle.
3. Remove the RH front wheel.
4. Remove the RH front splash shield.
1
Remove the three screws.
2
Remove the five pin-type retainers.
5. Remove the evaporative emission test port by disconnecting at the EVAP canister purge outlet tube junction.
INSTALLATION
1. To install, reverse the removal procedure.
-
Leak test the system. See: Testing and Inspection/Component Tests and General Diagnostics/Evaporative Emission System Leak Test
-
Carry out the evaporative emission repair verification drive cycle. See: Testing and Inspection/Component Tests and General
Diagnostics/Evaporative Emission Repair Verification Drive Cycle
